Now what are you making?

[RobbC]

Il hopefully get it started at the weekend, but i may be working so i dunno if il get the time.

Robb

[Adam Savage]

I'm off to Dartmoor at 9am tomorrow, for a couple nights, then from there over to the RV for the weekend. Not sure about after the RV, but I'll be sure to check in when I get back to civilization to see if you have started, and how far it's coming along if you have.

[paul standley]

Nice piece of work Saint. What tools/technique did you use, hand-carving, dremal etc ?

[Adam Savage]

Nice piece of work Saint. What tools/technique did you use, hand-carving, dremal etc ?

Dremel? don't swear at me LOL, I cheated a little with smoothing and used a belt sander, but only because I hadn't cut the piece parallel. I pinned the printout to the piece at the extremes of each letter, chiselled the outlines roughly with a 1/4" chisel, then carved each letter out with a craft knife.

[Roadkillphil]

Dremel? don't swear at me LOL, I cheated a little with smoothing and used a belt sander, but only because I hadn't cut the piece parallel. I pinned the printout to the piece at the extremes of each letter, chiselled the outlines roughly with a 1/4" chisel, then carved each letter out with a craft knife.

That is a nice piece of work Looks great

[CanadianMike]

Started another forged file knife (this one from a four in hand rasp I wore out), and also finished making a belt buckle.

[CanadianMike]

An ulu out of a cheap sawblade, and a forged knife from a four in hand rasp.



Mmmmm, snake scales!

[Adam Savage]

That is a nice piece of work Looks great

Thank mate, I think Ash liked it, well..I hope he did LOL. Nice spoon on the other thread too by the way. Will be waiting to see the fork.